Intel M20NTP1UR, Руководство по системной интеграции и обслуживанию

Страница: 83 / 114

Intel® Server System M20NTP1UR - System Integration and Service Guide
83
6.14 Server Board Replacement
Required Tools and Supplies
•
Intel® Server Board M29NTP2SB spare – iPC M20NTP2SB
• Anti-static wrist strap and conductive workbench pad (recommended)
•
Phillips* head screwdriver #2
1. Power off the system and disconnect all cables from the back of the system.
2. Remove the system top cover (see Section 6.1.1 ).
3. Remove the Air Duct (see Section 6.2.1 )
4. Remove the riser card assembly (see Figure 76 ).
5. (If Present) Remove the OCP* Module from the server board (see Section 6.8 )
6. (If Present) Remove the Intel® VROC Key from the server board (see Section 6.11 )
7. (If Present) Remove the M.2 SSD from the server board (See Section 6.10 )
8. Remove all memory modules from the server board (see Section 6.3 )
9. Remove processors from the server board (see Section 6.13 ).
10. Disconnect all cables attached to connectors on the server board.
11. Remove 9 screws used to secure the server board to the chassis (see Letter A Figure 109 ).
Figure 109. Server Board Removal
12. Slide the server board towards the front of the chassis to disengage I/O connectors from the back
panel Letter “B”).
13. Carefully lift the server board from the chassis and place it into an anti-static bag.