Intel M20NTP1UR, Руководство по системной интеграции и обслуживанию

Страница: 73 / 114

Intel® Server System M20NTP1UR - System Integration and Service Guide
73
6.10 M.2 SSD Replacement
Required Tools and Supplies
•
Replacement PCIe* M.2 SSD
• Anti-static wrist strap and conductive workbench pad (recommended)
•
Phillips* head screwdriver
1. Power off the system and disconnect all cable from the back of the system.
2. Remove the system top cover (see Section 6.1.1 ).
3. Remove the Air Duct (see Section 6.2.1 )
4. Remove the riser card assembly (see Figure 76 ).
5. Remove the M.2 SSD from the server board (See Figure 90 )
Figure 90. M.2 SSD Removal
• Slide the blue latch away from the M.2 SSD (see Letter “A”).
•
Carefully lift the free end of the M.2 SSD (see Letter “B”) and gently pull it out of the connector.
6. Locate and carefully unpack the replacement M.2 SSD. Hold it by its edges. Do not touch the gold
contacts.
7. Install the M.2 SSD to the server board (See Figure 91 )
Figure 91. M.2 SSD Installation
• Line up the alignment feature within the M.2 SSD edge connector with the alignment key within
the server board M.2 SSD slot connector.
• Carefully insert the M.2 SSD into the slot connector (see Letter “A”).
•
Push down on the free end of the M.2 SSD until it lays flat onto the latch assembly (see Letter “B”).
•
To secure the M.2 SSD to the server board, slide the blue latch over its back edge (see Letter “C”).