37
3-7-2 Onboard Device Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Device Function
Item Help
RealTek LAN BootROM Disabled
USB Host Controller Enabled
USB2.0 Function Enabled
USB Keyboard Legacy Support Disabled
USB Mouse Legacy Support Disabled
High Definition Audio Enabled
Menu Level >>
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
RealTek LAN Function
Setting to [Enabled] allows the BIOS to auto-detect the LAN controller and enable it. Setting
options:[ Enabled] and [Disabled] .
USB Host Controller
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller and you have
a USB peripherals. The settings are: Enabled, Disabled.
USB 2.0 Function
This setting allows you to enable/disable the onboard USB controller. Selecting [Enabled]
enables the system to support USB 2.0 spec. setting options:[Disabled],[Enabled].
USB Keyboard Legacy Support
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller and you have
a USB keyboard. The settings are: Enabled, Disabled.
High Definition Audio
The selection for you to choose the embedded Audio function or 3
rd
party audio interface
installed. The settings are: Enabled and Disabled.
3-7-3 Onboard Super IO Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Super IO Function
Item Help
Onboard FDD Controller Enabled
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART2 Mode Select Normal
IR Duplex Mode Half
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
ECP Mode Use DMA 3
Menu Level >>
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board
and you wish to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port 1 / 2
Select an address and corresponding interrupt for the serial ports. The settings are: 3F8/IRQ4,
2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, and Auto.