- 17 -
Advanced Functions
English
2.
TRANSMITTING
•
Press 2-Tone (9), 5-Tone (8) or DTMF key (9) to enter encoding menu item.
•
Use the Rotary Switch (4) to select the desired encoding group (1-32).
•
Press and hold the PTT key (16) to transmit the desired encoding tones.
•
Release the PTT Key (4) to cut off the encoding squelch.
TOT (Time Out Timer) SETTING
This function has two purposes :
1.
to allow, after a set time, to listen to other urgent calls.
2.
avoid to transmit for an endless time, in order to prevent overheating or damage to the
transceiver. After a programmable time of
15-1200 seconds (default setting is 180 seconds)
of
uninterrupted transmission, the transceiver automatically stops the transmission emitting a warning tone
(pre-set function). To stop the warning tone, release the PTT key (16). To restart the transmission, press
again the PTT key (16).
To set up this function, enter MENU mode and select the
TOT
function. Confirm the selection by
pressing the MENU Key (4) and use the Rotary Switch (4) to select the desired TOT Time, from
15 to
1200 seconds
or select OFF to disable the function.
Confirm the selection by pressing the MENU Key (4) and press the EXIT Key (6) to return to Stand-by
Mode.
TOT Pre-Alarm
The transceiver can setup the pre-alarm TOT (1-10s). Before 1-10s of TOT, the transceiver will sound a
beep.
TOT Delay Time
When the transmission exceeds the TOT setting, you can transmit again within TOT delay time (from 1
to 60 seconds).
Note :
This function is programmed by PC software
TOT Resume Time
The transceiver can setup the TOT resume time (1-15s). Before exceeding TOT, within resume time, if
you transmit again, the TOT will resume to add up the time. Or else the TOT will restart to record the
time.
Auto Resume to Main Channel
Set up a main channel by using PC software (the other channels will be secondary channels). In MENU
mode enter
HOCH
function and select
ON
to activate it. No matter in which channel you receive /
transmit, some seconds later (set by PC software), the radio will auto-resume to the main channel.
If no main channel is set, this function can not operate. If
HOCH
function is set as OFF (disabled), radio
can not auto-resume to main channel either even main channel is set.
Talk Around (Repeater channels only)
When this function is enabled, the RX frequency will be same as TX frequency. If CTCSS/DSC is set, the
encoding will become decoding.
In Menu mode, enter
TALK.AR
function and rotate the knob (4) to select OFF (function disabled) or ON
(function enables). Press MENU key (4) to confirm and press EXIT key (6) to return to standby mode.
Содержание MX-825U
Страница 47: ...Notes 46 ...
Страница 48: ......
