Integra DTR-70.4, Инструкция по эксплуатации

Страница: 51 / 120

Turning On & Basic Operations
En-51
The Whole House Mode is useful when you want to add
extra background music to your home party; this allows
you to enjoy the same stereo music as the main room in
separate rooms (Zone 2/3/4).
The Whole House Mode selects the same input source for
Multi Zone as the main room’s.
See also:
• “Speaker Setup” (
➔
page 62 )
• “Multi Zone” (
➔
page 84
)
You can set which speakers you want to use by priority. You can temporarily mute the output of the AV receiver.
Using the Whole House Mode
1
Press Whole House Mode on the front panel.
To cancel the Whole House Mode, press Off , change
the input source for the main room, or select a
listening mode (
➔
page 41 ).
Note
• (North American models) When using the Whole House
Mode with “ TUNER ” input selector, connect antennas to
both the MAIN and ZONE 2 ANTENNA jacks/terminals
(
➔
pages 20 , 86 ).
• The Whole House Mode only supports analog audio.
• To adjust the volume of Multi Zone, switch the AV receiver
to Multi Zone control. See “Adjusting the Volume for
Zones” (
➔
page 86 ) for the volume adjustment of Multi
Zone.
• The Whole House Mode is not available in the following
cases:
– The “
Audio TV Out ” setting is set to “ On ”
(
➔
page 81 ).
– “ HDMI Control(RIHD) ” is set to “ On ” (
➔
page 80 )
and you’re listening through your TV speakers.
– Digital Processing Crossover Network is used
(
➔
page 67 ).
Selecting Speaker Layout
1 Press Receiver followed by SP (speaker layout)
repeatedly to select:
■
9.2 ch playback
`
Speaker Layout:SB/FH :
The sounds from surround back and front high
speakers are output by priority.
`
Speaker Layout:SB/FW :
The sounds from surround back and front wide
speakers are output by priority.
`
Speaker Layout:FH/FW :
The sounds from front high and front wide
speakers are output by priority.
Note
• This setting is not available in either of the following cases:
– The “ Speakers Type(Front) ” setting is set to “ Bi-Amp ”
or “ Digital Crossover ”.
– The “ Passive Subwoofer ” setting is set to “ Yes ”.
– The “ Powered Zone 2/3/4 ” setting is set to “ Yes ” and
Zone 2/3/4 is turned on.
• Playback conditions may be limited depending on the set-
tings in “Speaker Settings” (
➔
page 63 ) and “Speaker
Configuration” (
➔
page 64 ).
• When a listening mode which doesn’t support front high,
front wide or surround back speakers is used, this setting
cannot be selected.
Important:
• The following layouts are only available when the “ 11ch
Playback ” is set to “ No ” (
➔
page 63
) and all
corresponding speakers are enabled.
Muting the AV Receiver
1 Press Receiver followed by Muting .
The output is muted and the MUTING indicator
flashes on the AV receiver’s display.
Tip
• To unmute, press Muting again or adjust the volume.
• Muting is automatically cancelled when the AV receiver is
set to standby.