Advanced Settings (Setup Menu)
En-38
Crossover
Allows you to change speaker configurations, such as crossover frequency. Settings are
automatically configured if you use the Automatic Speaker Setup. Audio will not be output
while you are making this setting.
●
If you are using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz" in "LPF of LFE".
– Set a value "Off" in "Double Bass".
Setting Item
Default Value Setting Details
Front
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
●
If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Center
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
●
"Full Band" can be selected only when "Front" is
set to "Full Band".
●
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Height
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
●
This cannot be selected when the setting for
"Configuration" - "Bi-Amp" is "Yes".
●
"Full Band" can be selected only when "Front" is
set to "Full Band".
●
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Setting Item
Default Value Setting Details
Surround
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
●
"Full Band" can be selected only when "Front" is
set to "Full Band".
●
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Back
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
●
This cannot be selected when the setting for
"Configuration" - "Bi-Amp" is "Yes".
●
"Full Band" can be selected only when
"Surround" is set to "Full Band".
●
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
LPF of LFE
120Hz
Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises. The
low-pass filter will be effective only on sources with
LFE channel.
The value from "80Hz" to "120Hz" can be set.
"Off": Do not use this function
Subwoofer Phase 0°
Bass sound of the subwoofers may be insufficient
depending on the type of sound and the listening
position. In that case, change the phase of
subwoofers. Set the phase value while listening to
the sound so that you can obtain your preferred
bass sound.
"0°": The subwoofer is in normal phase.
"180°": The subwoofer is in reverse phase.
●
The setting cannot be changed if "Configuration"
- "Subwoofer" is set to "No".
