Intec ColorCut FB1150 Series, Инструкция по установке и настройке

Страница: 30 / 44

Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 30
3.5. Calibration of the FB550 Cutter
The Intec ColorCut Flatbed engine needs to be calibrated befor e first use to ensu e
accurate cutting. There are 2 different calibrations that should be performed.
First (Section 3.5.1) , is to calibrate Tool2 (The Creasing Tool) to Tool1 (The Cutting Tool).
This calibration is performed using the front control panel of the cutter and aligns the
cutting and creasing tools together
.
If the Creasing Tool is NOT calibrated to the Cutting Tool, then your elements may
cut correctly BUT the crease will be performed in the wrong position.
The second calibration (Section 3.5.2) , aligns Tool1 (The Cutting Tool) to the position of
the Optical Sensor that r eads the Page ‘SMARTMarks’. This calibration is performed
using the ColorCut Pro software and is knows as the Sensor Offset.
If the SENSOR OFFSET is not calibrated then your cut position may be offset from
the position on the sheet that you actually wish to cut.
Calibrations are only r equired upon first use and normally do not need to be
carried out subsequently.
3.5.1 Calibration of the Creasing Tool to the Cutting Tool
The Intec ColorCut Flatbed engine is fitted with two tools. Befo e using your cutter for
the first time, you must align the two tools together so that cut lines and c eases are in
alignment with each other. To calibrate/align Tool2 with Tool1, the cutter will draw a 45
O
rotated square using the Creasing tool and then
use the PEN Tool to draw a square around it. The
rotated square SHOULD fit perfectly inside the
normal square. Please follow the steps below to
calibrate the Cutting Tool to the Creasing Tool.
1.
Place the Calibration Pen Tool
B
in to Tool
Holder 1
C
. (Normally the position for the
Blade Holder). Then place the Cr easing Tool
into Tool Holder 2
D .
2.
Using the LCD control
panel on the cutter , press
the MOVE/ Tab icon
along the bottom of the
display.
Using the
Left / Right keys
move the carriage so that
you can place a sheet of
paper on the cutting bed.
B
C
D