Inta Nulo CB10032CP, Инструкция по установке и обслуживанию

Страница: 7 / 24

© Intatec Ltd 2017
6
Fitting the Brackets
• Apply silicone sealer to the back of both wall brackets, fit to the 2 protruding copper pipes,
press to the wall and secure both brackets with 2 counter sunk screws.
• Add the olives and then the compression faces and tighten until water tight joints are made.
• Apply a bead of silicone sealer around the inside edge of the concealing plates, position
over the compression faces and press firmly to the wall.
Installing the Shower Valve
• The connector (10), check valve (9), filter (8), sealing washer (6) and union nut (11)
assemblies are factory fitted to the shower valve.
• Fit the shower valve to the wall bracket assemblies using the sealing washers (6) and using a
suitably sized spanned, tighten the union nuts taking care not to damage the finish on the
shower valve, do not over tighten.
• Turn on the water supplies and check that all joints are water tight.