© Intatec Ltd 2015
9
Maintenance
Cleaning
ATTENTION
: Turn of the water supply at the ball valve before removing the filter.
Some supplies can contain particles and impurities which could damage the solenoid valve.
As part of package, a water supply filter is included which must be kept clean to ensure
maximum water flow.
Clean the filter by washing thoroughly using running water.
Battery Replacement
When the battery is exhausted, the LED flashes continuously and the solenoid valve stops in the
closed position.
Remove the exhausted battery and repeat the operations described in the section “Activating”
in order to re-store the operation of the tap.
Trouble Shooting
The following details are supplied for on site queries, should further assistance be required our
Technical Department can be contacted directly on 01889 272199
Fault
Cause
Solution
No water flow
The isolation valves are closed
Open the isolation valves
Exhausted battery (LED flashes)
Replace the battery
Electrical problem
Check the voltage
Disconnect and reconnect the battery (where
applicable)
Check the connections and the cable’s
integrity
Damaged sensor: ask for assistance
Dirty sensor
Clean the sensor window
Filters are dirty
Close the isolation valves and clean the
filters
Blocked solenoid valve
Ask for assistance
The water flows for 1
minute (without
any object in front of the
sensor), finally stops
Dirty Sensor
Clean the sensor window
Light reflection on the sensor
Remove the reflective surface
Electronic problem
Disconnect and reconnect the battery
The water flows for more
than 1 minute
Blocked solenoid valve /
damaged sensor
Ask for assistance
