© Intatec Ltd 2015
4
Pre-installation Information
Warning
• Do not install the tap facing a mirror or any other electronic system operated by an infra red
sensor.
• To prevent reflection problems, it is recommended to keep a minimum distance of 1.5m
between the tap and other objects.
• Do not expose the tap to temperatures lower than 5°C (for example during winter time):
otherwise arrange for the system to be drained.
• Adequate provision must be made to ensure the water quality (including limescale); the
presence of debris may damage the solenoid valve.
• For pre-mixed water a thermostatic mixing valve with integral isolating valves should be
installed in the supply pipe to the HOT connection of the tap.
• We recommend that a service valve and check valve are installed in the supply pipe to the
COLD connection of the tap should maintenance be required in the future.
Preparation for installation
Flush the water supply pipes thoroughly prior to installation. Do not allow debris, PTFE tape or
any metal particles to enter the tap.
Turn off the water supply.
Important
- All plumbing to be installed in accordance with applicable codes and regulations.
Installation
FAILURE TO OBSERVE THE INSTALLATION INSTRUCTIONS WILL INVALIDATE THE PRODUCT
WARRANTY CONDITION.
1 Screw the flexible hoses (5) into the inlet nuts (6) and the threaded rod from the fixing kit
into the base of the tap.
2 Locate the ‘O’ ring from the fixing kit into recess in the base of the tap.
3 Position the tap (1) into the hole in the basin and secure using the horse shoe washer and
retaining nut from the fixing kit (2).
4 Connect the flexible hoses (5) to the water supplies using the ½” sealing washers (7) and
make water tight joints.
ATTENTION
: failure to fit filters on the supply pipes can damage the solenoid valve and
automatically invalidate the product warranty.
5 Fix the power supply unit (3) using the screws (4), ensuring the power cable exits from the
bottom as shown.
ATTENTION
: Do not connect the power supply until it required.
