TwinLock
Assembly Instructions
18
Version 1.12
The electronic lock must be fastened with 4 screws M6. Suspension mounts
B
,
see
detail drawing below. The screws mut be directed through the
intended drillings from the base side of the electronic lock box. To avoid loosened
screws, we recommend to place washers under the screw heads. To avoid system
malfunctions, the screws must be tightened with a maximum torque of
10 Nm
.
After having been installed, the lock bolt may not be under tension or pressure.
The maximum bolt stress in unlocking direction is 50 N.
The protruding of the locking bolt may be steplessly adjusted from 9mm to 15mm.
Bolt hub 15mm
(attention: the protruding of the locking boltmay be adjusted just
by extended bolt! )
When used in normal living and office environments the electronic lock is
maintenance-free. After approximately 10,000 shuttings, a security and function
check of the electronic lock by
INSYS
-trained staff is recommended.
Failure to comply with the installation instructions or opening the lock case by not
INSYS
-trained staff will render the manufacturer’s warranty invalid.
Dimensions and drilling jig
