Instron 1000KPX-J3, Руководство по концепции системы

Страница: 27 / 58

27
Interconnections
Product Support: www.instron.com
Initial startup
Equipment required
•
A torque wrench (supplied)
•
A ratchet wrench (supplied)
•
A 6 mm hex key (supplied)
•
All tools for your frame model that are listed in Table 3
Recommended procedure
1. Verify that the following have been completed:
• The frame is secured to the foundation (if required)
• The HPS reservoir is filled with the appropriate amount and type of oil
• The air breather assembly is installed on the fill hole of the HPS reservoir
• All system interconnect cables are installed and have secure connections
• All Operating Instructions and accompanying documentation for the system have been read and
understood by the operator
• Any shipping hardware (typically painted red) has been removed from the frame
• For systems that have optional high-capacity external grips mounted in the test space, verify that
the grip brackets have been removed from between the upper and lower grips
2. Locate the Operating Instructions that were supplied with the system. You will be required to refer to
procedures and information that are provided in the Operating Instructions as you perform the initial
startup.
Table 3. Tools required per frame model.
Frame Model Instron Supplied Tools Customer Supplied Tools
600KPX-J3
•
5/16 in hex-bit socket
•
27 mm hex-bit socket
3/4 in square-drive wrench
1
1000KPX-J3
•
5/16 in hex-bit socket
•
36 mm socket
•
Piece of 36 mm hex stock
1 in square-drive wrench
1
1500KPX-J3
•
3/8 in hex-bit socket
•
36 mm socket
•
Piece of 36 mm hex stock
1 in square-drive wrench
1
2000KPX-J3
•
3/8 in hex-bit socket
•
Spanner wrench
•
36 mm socket
•
Piece of 36 mm hex stock
•
6 mm hex key
1 in square-drive wrench
1
1. The wrench must have a handle length (or extension) that provides enough leverage to loosen a bolt that has been
tightened up to 810 N-m (600 lbf-ft) - a handle length (or extension) of 1 m (40 in) or longer is recommended.