3
SAFETY INFORMATION
Please read the following carefully before starting work on this equipment.
A competent person should install this appliance in accordance with the installation instructions (see
separate booklet), and all relevant local and national standards including the following:
-
Health & Safety at Work Act
-
IEE Regulations
-
Local & national Building Regulations
-
BS Codes of practice
-
Water Supply Regulations
All personnel should be provided with sufficient training in the use of this appliance.
In line with Health and Safety requirements we recommend a risk assessment be carried out
after the dispenser has been installed.
Always disconnect the unit from the power supply before servicing.
The unit must be earthed.
Keep these instructions in a safe place near the unit for future reference
IMPORTANT: It is essential that the UCCH1000 chilled water dispenser is installed correctly. Failure to
provide sufficient air-flow and ventilation and adequate expulsion of warm exhaust air will seriously
impair the performance of the chiller and may cause over-heating which will invalidate the
guarantee. Refer to “Installation Information & Instructions” separate booklet.
This appliance is not intended for use by persons (Including Children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure they do not play with the appliance
PRE-INSTALLATION:
IMPORTANT: The UCCH1000 contains a refrigeration system. Therefore, upon receipt, the appliance
should be left standing upright for approximately 12 hours, before installing and switching on. This is
because, during transportation, if the unit has not been kept totally upright, the oil inside the
compressor may have leaked into the refrigeration system and will need time to settle. Failure to do
this, may lead to a breakdown due to a system blockage.
INITIAL PRIMING OF CHILLER & SWITCHING ON:
Following installation and mains water connection, plug unit into a 13A socket and switch on. Prime the
unit with water as described in SECTION 7 of Installation Instructions booklet.
SETTING THE CORRECT WATER FLOW RATE:
Set correct water flow rate as described in SECTION 8 of Installation Instruction booklet. Note: If the
flow-rate is too fast, the water will pass through the cooling block to quickly and drink may not be as
cool as it should be.
