Insta 256 Series, Руководство по эксплуатации и обслуживанию

Страница: 6 / 28

5
FOR USE BY QUALIFIED PERSONNEL ONLY
Configuring Your Machine
Once you have correctly installed your machine
will want to configure the settings of your machine
to match your needs.
1. Turn the machine on
Plug your machine in, turn
power switch on, and press the
button on the control panel.
The display will briefly show the
controller program revision number.
2. Set the operating Temperature
a. If the temperature is not shown, press
MODE to cycle to the temperature
display.
NOTE:
If the platen temperature is
BELOW 225
°C, the controller will display “ Lo F ” or
depending on the units the controller is set to.
b. Press SET to display the current set
temperature.
To raise the temperature, hold
UP .
+
To decrease the temperature, hold
and
DOWN .
+
3. Give the machine time to heat
FOR USE BY QUALIFIED PERSONNEL ONLY
your machine, you
will want to configure the settings of your machine
turn the main
and press the POWER
.
The display will briefly show the
ontroller program revision number.
emperature
If the temperature is not shown, press
to cycle to the temperature
25 °F OR 107
” or “ Lo C ”
depending on the units the controller is set to.
to display the current set
To raise the temperature, hold SET and
To decrease the temperature, hold SET
Give the machine time to heat
NOTE:
Heating may take between 20
minutes
depending on the set
temperature. Do not leave the
machine unattended during this time!
2
1
2
+
2
2
+
Heating may take between 20 to 45
minutes
depending on the set
temperature. Do not leave the
machine unattended during this time!
1
1
1