15
Adjustment running belt
a) Turn the speed to be 6km/h for running.
b) Turn the both tension screws located at the end of the treadmill on the right and left sides, half a turn
clockwise using the Allen key. (Diagram1 and Diagram 2)
c) After adjustment, running belt still slips; please repeat the steps as above.
Tighten the running belt (Diagram 1)
Loosen the running belt (Diagram 2)
The adjustment steps for running belt deflection
The running belt will be deflected more or less under using. Then it needs to be adjusted. The steps are as
follows:
a) Place the treadmill on a horizontal floor, turn the speed to be 6 km/h for running.
b) If the running belt is deflected to the right, adjust the bolt on the right by turning it for half a turn
clockwise, then adjust the bolt on the left by turning it half an anti-clockwise.(see Diagram 3)
c) If the running belt is deflected to the left, adjust the bolt on the left by turning it for half a turn clockwise,
then adjust the bolt on the right by turning it half a turn anti-clockwise.(see Diagram 4)
d) After the adjustment, the running belt still keeps deflecting, please repeat the steps above.
The adjustment for right deflection (Diagram 3)
The adjustment for left deflection (Diagram 4)
Running board lubrication- Silicone oil has been provided (White Bottle)
The treadmill is brand-new and has been pre-factory lubricated. Lubrication is not necessary directly after
purchase.
Lubrication needs constant maintenance termly after purchase. The friction between the running board and
running belt has a great effect on the treadmills’ life. So please lubricate your machine termly (every one month).
The steps are as follows:
Step 1.
Please unplug power supply for the treadmill and loosen the belt (Belt tension screw located at the end of
the treadmill).
Step 2.
After loosening the screw, lift up the running belt and clean in-between the running board. Squeeze the
small white bottle of SILICONE oil which was supplied with your purchase and wipe it evenly across the board.
Step 3.
After lubricating the board, screw the belt tension back to its correct tension. Tighten evenly on both
sides. When it is almost tensioned, run the treadmill at 1km without any load. Adjust both tension screws to make
the belt in the centre of the back roller. Run the treadmill at 5km for 3mins.
Step 4.
Stop the treadmill and start to walk on it at 5km/h. Lastly fine tension both screws until
it’s running
smoothly with your weight on.
