15
MAINTENANCE
Identification ways for the degree of tightness of running belt and poly V-belt.
When the running belt skips, please follow the steps as follows to make sure which belt needs to be adjusted,
running belt or poly V-belt.
a)
Unplug all power supply, screw and remove the Base cover.
b)
Turn the speed to be around 3km/h, step on the running belt by pressure and try your best to make the
running belt stop. If running belt stops, together with the front roll, but the motor still runs, under this
condition, it means the poly V-belt needs to be adjusted.
c)
Turn the speed to be around 3km/h, step on the running belt by pressure and try your best to make the
running belt stop. If running belt stops, but front roll still runs, under this condition, it means the
running belt needs to be adjusted.
The adjustment steps for poly V-belt
a)
Unplug all power supply and take off the base cover.
b)
Loosen the four screws for the motor, adjust the V-belt tension bolts in clockwise direction, and then
tighten back the four screws for the motor.
Adjustment running belt
a)
Turn the speed to be 6km/h. for running
b)
Turn the both tension screws located at the end of the treadmill on the right and left sides, half a turn
clockwise using the Allen key. (Diagram1 and Diagram 2)
c)
After adjustment, running belt still slips; please repeat the steps as above.
Tighten the running belt (Diagram 1)
Loosen the running belt (Diagram 2)
The adjustment steps for running belt deflection
The running belt will be deflected more or less under using. Then it needs to be adjusted. The steps are as
follows:
a)
Place the treadmill on a horizontal floor, turn the speed to be 6 km/h for running.
b)
If the running belt is deflected to the right, adjust the bolt on the right by turning it for half a turn
clockwise, then adjust the bolt on the left by turning it half an anti-clockwise.(see Diagram 3)
c)
If the running belt is deflected to the left, adjust the bolt on the left by turning it for half a turn
clockwise, then adjust the bolt on the right by turning it half a turn anti-clockwise.(see Diagram 4)
d)
After the adjustment, the running belt still keeps deflecting, please repeat the steps above.
The adjustment for right deflection (Diagram 3)
The adjustment for left deflection (Diagram 4)
Running board lubrication- Silicone oil has been provided (White Bottle)
