
Trouble Shooting
TROUBLE SHOOTING GUIDE:
SYMPTOM
CAUSE
SOLUTION
Show E0
Not equip Safety key
Please equip the Safety key
Show E1
Speed feedback equipment err
Please check Speed feedback equipment and 10-
pin cable or contact special service
Show E2
Motor or Motor drive err
Please check PIN cable or contact special
service
Show E3
The error of Speed over limit
Adjust Speed feedback equipment or contact
special service
TROUBLESHOOTING YOUR TREADMILL:
This treadmill is designed to be reliable and easy to use. However, if you experience a problem, please
reference the trouble shooting guide listed below:
PROBLEM: The console does not light up.
SOLUTION: Verify that the power cord is plugged in properly to the outlet, and the treadmill switch is
turned on.
PROBLEM: The treadmill circuit breaker trips during a workout.
SOLUTION: Verify that the treadmill is plugged into a dedicated 20amp circuit.
*Note: No extension cord.
PROBLEM: The treadmill shuts off when elevating.
SOLUTION: Verify that there is enough slack in the power cord to reach to the wall outlet during
elevation.
PROBLEM: The running belt does not stay centre during a workout.
SOLUTION: Verify that the treadmill is on a level surface. Verify that the belt is properly tightened.
(Refer to belt adjustment)
PROBLEM: The treadmill makes a clicking noise towards the front of the machine while walking or
running on it.
SOLUTION: For optimum use, the treadmill needs to be level.
General fitness tips
Start your exercise programme slowly, i.e. one exercise unit every 2 days. Increase your exercise session
week by week. Begin with short periods per exercise and then increase these continually. Start slowly
with the exercise sessions and don’t set yourself impossible targets. In addition to these exercises, do
other forms of exercise such as jogging, swimming, dancing and/or cycling.
Always warm up thoroughly before exercising. To do so, carry out at least five minutes of stretching or
gymnastic exercises to avoid muscle strains and injuries.
Содержание Gallop
