Inspired by drive CSI-2000, Руководство пользователя

Страница: 14 / 24

14
Installation (continued)
6. Make sure that the seat belt in not twisted, then buckle in place.
7.
Make sure the restraint system is fl at against the vehicle seat’s
bottom and back. Use your hands to apply fi rm pressure to the
restraint, pushing it into the vehicle backrest or better yet, place
your knee on the restraint and push down with all your weight while
pulling on the vehicle seat belt and removing all slack from it.
8. Check to make sure the tether strap is not twisted and then tighten to
secure the upper portion of the restraint. If the vehicle does not have
a top tether anchor point, it will be necessary to use a bolt-in anchor
mounting bracket.
See Installation Without LATCH Top Tether
Anchors.
9. DO NOT USE this restraint without the tether strap properly installed.
10. Verify that the vehicle seat belt is tight and that the Positioning
Restraint System is secure. When properly installed, the restraint
will not move more that 1” (25mm) from side to side and or front to
back. If the restraint is not secure, repeat steps 4 - 7.
Aircraft Installation
1. Place the Positioning Restraint System in a forward facing position
on the vehicle seat. If the front edge of the restraint extends
more that 1” (25mm) beyond the front edge of the seat, then
the vehicle seat is too shallow to properly support the restraint
system. If this is the case, do not install.
2. Pull the lap belt out completely, then route the belt between the back
of the restraint and the metal tubes which are located along the sides
of the Positioning Restraint System.
3. Make sure that the seat belt in not twisted, then buckle in place.
4. Make sure the restraint system is fl at against the vehicle seat’s
bottom and back. Use your hands to apply fi rm pressure to the
restraint, pushing it into the vehicle backrest or better yet, place
your knee on the restraint and push down with all your weight while
pulling on the vehicle seat belt and removing all slack from it.
5. Verify that the vehicle seat belt is tight and that the Positioning
Restraint System is secure. When properly installed, the restraint
will not move more that 1” (25mm) from side to side and or front to
back.