Cable End with
Bushing
Pulley 1
Pulley 3
Pulley 5
Pulley 7
Pulley 8
Pulley 6
Pulley 9
Pulley 4
Pulley 2
STEP 9
STEP 11
STEP 10
Remove these items from machine.
Save Washers and Lock Nut for use
in Step 10.
2 – M10 x 45 Hex Bolts
4 – M10 Flat Washers
2 – M10 Lock Nuts
1 – 8” Hex Bolt
2 – 3/8” Small OD
Washers
1 – 3/8” Lock Nut
Step 9: Remove the two Bolts, three Washers, one Lock Nut, Mounting Bracket, and Barrel
Spacer from the Upper Pulley on the M5. Save the Washers and Lock Nut for use in
Step 10. Leave the Lat Upper Cable wrapped around this pulley.
Step 10: Attach the previously installed 3 ½” Pulley and Two (M10 x 45 Hex Bolts)
Pulley 9 to two Floating Pulley Plates using: Four (M10 Flat Washers)
Two ( M10 Lock Nuts)
Step 11: Attach one Cable End with Bushing to one end of the cable as shown. Attach the Cable
End, Bushing, and 3/8” Washer to the Leg Press Base with the 8” Hex Bolt. Run the
other end of the cable around Pulleys 1, 3, 5, 7, 9, 8, 6, 4, and 2. Attach the other
Cable End with Bushing to this end of the cable and attach to the 8” bolt with one 3/8”
Washer and 3/8” Lock Nut.
Note: Hardware in Steps 9 & 10 are metric sizes. Do not mix hardware from Steps 9 &
10 with Hardware in Step 11.
Page 5
Leg Press Base
Previously installed 3 ½” Pulley
And Lat Upper Cable