11
OpERATIONAL INSTRUCTIONS
Diagram 1
Diagram 2
Adjusting the seat height
1. Unscrew the hand wheel.
2. Adjust the seat up or down to your required height. To line it up correctly, make sure the
number and line is visible at the top of the seat post mounting tube.
3. Re-screw the hand wheel and make sure it is screwed tightly.
4. The basic rule of getting the seat height right is that as the pedal reaches its lowest point,
the leg is almost straight.
Do not pull the seat out too far. The maximum is indicated with a piece of tape on the seat.
Leveling your cycle
To help you level the cycle on uneven surface, 2 height adjusters are included on
the rear stabilizers. Simply twist these around to adjust the height of the cycle.
Battery replacement instructions:
1. Open the battery compartment cover (Diagram 1).
2. Remove battery by pulling the battery in direction of spring and
lift opposite end upwards (Diagram 2).
3. Insert 2 AA batteries ensuring you match the polarity markings
(+ and -) on the batteries with the indicators in the battery
compartment. Push flat end ( - ) against spring and when clear
push other end into holder.
4. Close the battery compartment.
Tips & Warnings
• Always change both batteries at the same time.
• Always use the same type of batteries.
• Never recharge Alkaline AA batteries.
• Do not try to heat, ignite, disassemble or throw AA batteries into
a fire.
• Do not leave old batteries in the console, and remove batteries
from the console if you won’t be using it for a long time.
Protect the environment by not disposing of this
product or batteries with household waste. Check your
local authority for recycling advice and facilities.
* PICTURE MAY VARY FROM ACTUAL MODEL.
Содержание Pursuit Exercise Cycle
