INSIGHT 4K Dual LED Series, Инструкция по установке и быстрому запуску

Страница: 19 / 84

page 13
Digital Projection INSIGHT 4K Dual LED & Quad Series
Installation and Quick-Start Guide
PROJECTOR OVERVIEW
Rev B June 2016
Remote control troubleshooting
The remote control is shipped with no battery fitted. Remove the back cover and insert the
supplied cells while observing the correct cell polarity.
If the projector fails to respond to keypress on the remote control, consider the following checks.
Does the Transmit indicator flash when a key is pressed?
The blue Transmit Indicator
1
should be dark when the remote control is not being used and
flash when a key is being pressed.
•
If it emits a solid light when a key is not being pressed, the remote control is in LENS
ADJUSTMENT mode. Press
EXIT
or wait up to ten seconds to exit LENS ADJUSTMENT
mode.
•
If the Transmit indicator fails to flash when a key is pressed, it might be time to replace the
battery. Use only Alkaline AAA (LR03) cells for best results.
Does the indicator on the projector respond when a remote control key is pressed?
When a key is pressed on the remote control, the infrared indicator
2
on the connection panel
should flash blue. If this does not happen:
•
Check that the angle of acceptance is met.
•
Check that the projector address matches the remote control address.
•
If none of the above fixes the problem, it might be time to replace the battery. Use only
Alkaline AAA (LR03) cells for best results.
Notes
The infrared receivers are disabled
when a remote control is connected
via a cable. For more information,
see Control Connections in the
Connection Guide
.
For information about the angle of
acceptance, see
Infrared reception
earlier in this guide.
2
Infrared indicator
on the Connections panel
LAMP
1 2
3 4
SERIAL ERROR IR WIRED REMOTE
IN OUT
IN OUT
3D SYNC HDMI
A B A B
DISPLAYPORT
OPTION POWERHEALTH
A B
VGA HDMI DVI 3GSDI
CVBS1 SVIDEO
CLOSE
1
2 3 4
COMP CVBS2
5 6 7 8
9 0 10+ #
MAIN SUB DUAL HD-T
OFF ON
ALT
ROLL
PITCH YAW
FOCUS
CAL
SHIFT
ZOOM
EYE
SWAP
MAIN/PIP
SWAP
BRI
CON GAMMA
3D
ON/OFF
PIP
ON/OFF
LOAD SAVE TEST ADDR
BACKLIGHT
R G B
PRESET
SHUTTER
OPEN
POWER
MENU
OK
EXIT
INFO
Transmit indicator
on the remote control
1