Insight Vision Vutek, Руководство пользователя

Страница: 6 / 22

5
exposed, there exists the risk of grit wearing down or possibly even tearing the O-ring. It is also possible for
water to then enter the connection area once exposed. All connections, once opened or exposed, MUST
be thoroughly cleaned and dried before re-connecting. We recommend using an old toothbrush or other
soft bristled brush to clean the O-ring areas and remove the grit or fine debris. Then, completely dry the area
around male and female connector and the O-ring before re-connecting.
Sonde:
The sonde
transmit a 512hz frequency so that it’s locatable with a locator. We recommend after every
inspection, power off the system and disconnect the sonde. Wipe down the sonde with a damp towel and check
for damages or missing O-rings on the male and female connector. Read O-Rings above when re-connecting.
Camera Head:
All Vutek camera heads are covered for one (1) year under the standard warranty against all defects in
workmanship. These cameras are all sealed and water-resistant. Warranty coverage will apply for any and all
internal failures to the camera head unless external damage is evident. This would include a broken window
and any deformation to the stainless steel metal housing of the camera head.
NOTICE:
The system has provided protective 2” and 3” skids that MUST be used at all times. These
skids are designed to aid in the centering of the camera head and have the added benefit of helping to
protect the camera head from extreme wear. Failure to use the provided skids will result in the direct
wear of the metal, especially at the front window array, resulting in the eventual wearing down of the
metal. This wear could result in a breach of the window seal allowing water into the camera head. This
type of wear will not be covered under warranty.
Hub Assembly:
The hub assembly houses the encoder, the wiring terminals, and solders joints that are susceptible to water
damage. Although it is very well covered and enclosed, the electronic components are not water-proof. Only
wipe with damp cloth when cleaning. You will find the warning label on the hub assembly:
NOTICE: DO NOT POWER WASH THE HUB ASSEMBLY AREA.
Push Rod:
The Vutek push rod terminations are covered for one (1) year under warranty. This warranty policy covers
workmanship on the termination connection ONLY and does not cover push rod breakage or kinks in other
parts of the rod. While recoiling your push rod, wipe down with damp rage and check for kinks, or cracks after
every inspection.