Date: November 2016
Issue No: 2
Crewsaver -
Servicing Manual : Inshore 380N Lifejacket
Page
of 31
13
3.1
Unpacking the Inshore 380N
WARNING: All defects should be noted onto the service record sheet.
3.1.2
Following unpacking refer to:
a.) Manual Operation: Fig 3.2 - Halkey Roberts operating head removal.
3.1.2.1.2 Carefully remove the inflation cylinder by unscrewing it from the operating
mechanism. Retain for further Inspection. Refer to Section 5.
3.1.2.1.3 Remove Operating Mechanisms (and upper and lower manifold gaskets) by
unscrewing the retaining nut on the top of the inflation mechanism. Retain for further
Inspection. Refer to Section 5.
3.1.3.
Remove light and battery. Place to one side for further inspection. Refer to section 5.
3.1.4
Remove Safety Line and place to one side for further inspection. Refer to Section 5.
3.1.5.
For Cleaning. Refer to Section 4.
3.1.6.
Carry out visual inspection. Refer to section 5.
3
Section
OPENING THE LIFEJACKET COVER
1. Open the velcro tab.
2. Pull apart the zip, opening the zip via
the 3 quick burst elements, holding the
cover either side.
3. Once the zip has opened insert your
finger and slide it around the Lifejacket.
Undo the zip all the way around the
outside of the lifejacket. The Lifejacket
cover should now be open and the
inflation chamber visible.
Fully separate the zip. Both sides of the
zip should be apart, with the zip slider
free to move back around the lifejacket
to the start.
