SS-GM-02 Owner’s Manual
Document: OM-236 Version Code: A
Date: May 06, 2020 Date: Feb 05, 2021
© Copyright 2021 InPower LLC
Page
5 of 8
InPower LLC
8311 Green Meadows Drive
Lewis Center, Ohio 43035 USA
740-548-0965
www.InPowerLLC.com
2. Installation Procedures
WARNING
2.1 Safety Precautions
This electronic Start/Stop/Elevated Idle product has been designed
and manufactured to meet the intended application requirements and
specifications. Any modifications to the product or to the installation procedure
can be dangerous and will void InPower’s warranty.
•
Read and understand the instructions in this manual and other manuals
before starting the installation.
• Make sure that the vehicle battery power is disconnected during the
installation of the Start/Stop module.
• Reconnect the battery when the system installation is complete
.
•
Wear appropriate safety equipment, such as protective eyeglasses,
faceshield and clothing when installing equipment and handling the battery.
•
Be careful when working near a battery. Make sure that the area is well
ventilated and that there are no flames near the battery. Never lay objects
on the battery that can short the terminals together. If battery acid gets in
your eyes, immediately seek first aid. If acid gets on your skin, immediately
wash it off with soap and water.
2.2 Getting Started
IMPORTANT NOTE
: Once again! Please obtain the specific PTO
installation instructions for your vehicle make and model from GM. Wire
colors and locations may vary from model to model and even between
different years for the same model. The guide may be obtained from
GM’s Upfitter Integration Bulletin 120F
(or latest revision thereof)
.
The SS-GM-02 is designed for Frame Rail Mounting. It is designed to IP66 (No
ingress of Dust and able to withstand water spray).
You will need tools to splice wires together. For each the Start/Stop/Preset
Idle settings you will need different switches. They also can be configured to
be steady signals. This is all in the desired configuration of the control lines.
Carefully disconnect the battery before making any electrical connections.
2.3 Required Installation Hardware
#10 Mounting hardware (bolts and nuts)
Connector to match your chassis specific PTO Solenoid
Connector to match your chassis specific PTO Pressure Switch
