SS-GM-02 Owner’s Manual
Document: OM-236 Version Code: A
Date: May 06, 2020 Date: Feb 05, 2021
© Copyright 2021 InPower LLC
Page
2 of 8
InPower LLC
8311 Green Meadows Drive
Lewis Center, Ohio 43035 USA
740-548-0965
www.InPowerLLC.com
1. Introduction
InPower’s SS-GM-02 Start/Stop/Elevated Idle Module interfaces with the GM
PTO Upfitter Connector to provide you with the signals you need for Elevated Idle
selection and Start/Stop Functions. This product is compatible with (Diesel Only)
2019+ GM 4500-6500 and Navistar CV vehicles.
Please refer to the
GM Upfitter Integration Bulletin 120F
(or most current revision
of 120) for up to date information for the integration of this system.
This programmable PTO controller interface provides Start, Stop, and two preset
RPM modes. It provides a +12VDC and Ground True input control for Start/Stop
and Elevated RPM functions - All of these Inputs are activated as a momentary
switch connection. The SS-GM-02 also supplies a Start/Run Status Output and
an optionally configured Output. The programmable nature of this unit allows
the customization of these inputs to meet customer requirements and service a
wide variety of application interfaces. For custom requirements, please contact
InPowerLLC for your needs.
InPower LLC
8311 Green Meadows Drive
Lewis Center, Ohio 43035
740-548-0965
www.InPowerLLC.com
The SS-GM-02 is directly interfaced to the GM PTO Controller which constantly
monitors chassis conditions and co-ordinates requests from the SS-GM-02. It
connects to the PTO Upfitter Connector and thereby the GM PTO Controller.
The SS-GM-02 kit includes a harness for connection to the PTO Upfitter Connector
and the PTO itself. This harness consists of a connector (P1) to connect to the
GM PTO Upfitter Connector, and the other connector (P2) for the connection to the
SS-GM-02. The SS-GM-02 is then connected to the PTO via 4 Blunt-Cut wires:
PTO-CTL, GND, PTO-FB, and +12V. These wires to the PTO will be terminated
with user supplied, PTO appropriate connectors dictated by the type of PTO that
is installed. There are also 8 Blunt Cut wires provided for the User Interface and
Control of the SS-GM-02 Module. These provide Start/Stop and RPM selection,
Status output, and a +12V Power Input.
Note 1
:
GM vehicle wire colors and locations may vary substantially between
different models and even different model years.
Please obtain and consult
the PTO Control information for your specific vehicle prior to installing
the module
. Documentation may be obtained from GM’s Website.
Note 2
:
Please refer to your PTO manufacturer for the appropriate PTO
connectors for PTO-FeedBack and PTO-Control.
