Installation
INOXPA S.A.U.
20.005.30.01EN · (0) 2019/02
11
5.6. ASSEMBLY
To locate and fix the agitator in the support flange of the tank, the propeller must be removed from the shaft.
Once the base of the agitator is placed on the supporting flange, the fixing nuts and screws will be assembled in
their corresponding holes, without being tightened. When this operation has been carried out, the agitator must
be levelled using the following method:
1. Place a spirit level against the shaft.
2. Check 4 points at 90º to each other around the circumference of the shaft and at the same height.
3. Once the shaft is level, firmly tighten the fixing nuts and screws. Finally the propeller is mounted on the
end of the shaft. Be careful when assembling the shaft not to hit or strain it so as to avoid it being bent.
Force should never be applied to the end of the agitator shaft, as it can easily suffer permanent
damage.
Check the alignment of the agitator shaft with the half shaft once its assembly is completed.
ATTENTION
ATTENTION
