Inovonics 525N, Инструкция по установке и эксплуатации

Страница: 20 / 51

— — 16
No. Menu Page No Menu Page
1
SET FREQUENCY
PEAK MODULATION
16,
17
8 CLOSURE POLARITY 23
9 NETWORK: DHCP 25
2 SIGNAL AND NOISE 17 10 NETWORK: IP 25
3 SET OPTIONS 23 11 NETWORK: GATEWAY 26
4 SET PEAK FLASH 19 12 NETWORK: SUBNET 26
5 SET OVERMOD 19 13 NETWORK: DNS 26
6 SET LOW SIGNAL 21 14 NETWORK: PORT 29
7 SET AUDIO LOSS 22 15 FIRMWARE UPDATE 43
TUNING
From the No 1 ‘home’
PEAK MODULATION
screen, press the up-
per
MENU/EDIT
button so that
SET FREQUENCY
replaces
PEAK
MODULATION
in the
MENU AND ALARMS
title area.
Use
SEL
buttons to set the receive frequency, which always ap-
pears in the upper-right corner of the LCD. Hold the
SEL
but-
tons down to scan quickly up or down the band, or push re-
peatedly to tune in single-channel steps.
Tuning
Lockout
60 seconds after setting the frequency, the
SET FREQUENCY
screen defaults to show
PEAK MODULATION
. When the title of
this screen changes, the
SEL
(select) buttons are locked out.
To return to
SET FREQUENCY
, press the upper
MENU
button.
Tuning
Increments
Tuning steps may be set either to the 10kHz increments com-
mon to the Western Hemisphere, or to 9kHz steps for Europe
and other areas. Scroll down to Menu No. 3,
SET OPTIONS
, to
set channel spacing for your area.
Tuning Presets
Up to five stations may be entered into non-volatile memory
for instant recall. Station preset buttons will tune the 525N
regardless of what screen is showing. To set the front-panel
buttons, simply tune the 525N to the desired frequency and
then hold down one of the buttons in the
STATION PRESETS
group. After a couple of seconds the frequency readout will
‘wink’ to indicate that the memory has been set. Repeat the
process to enter other frequencies or to update any memory
entry.
If staying-tuned to the station’s frequency is critical, set all five
STATION PRESETS
to the same frequency to guard against ac-