icon flashes. If reception continues to fail, try other locations later. Place the unit away from source of interference
such as mobile phones, appliances, TV etc.
To disable the radio-controlled time reception and stop the daily synchronization, continue pressing until the
antenna icon disappears.
16/ CLOCK & CALENDAR
Press “CLOCK” to toggle display between time, calendar and day of the week.
Clock & calendar setting:
Note: You need to set clock & calendar when your weather station cannot receive radio-controlled time signal in
your location.
- Hold “CLOCK “ button to enter clock setting mode.
- Using “
▲
”or “
▼
“ to adjust and “CLOCK” to confirm, the following values can be set in sequence:
12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > EXIT
17/ HOME TIME, WORLD (ZONE) TIME
Hold “ZONE” to enter world (zone) time setting mode. Press “
▲
“or “
▼
“ to enter the desired hour offset value from
–12 to +12 hours. Press “ZONE” to confirm each setting.
Press “ZONE“ button to toggle between home (radio-controlled) time and world (zone) time. “ZONE” icon appears
when world (zone) time is selected. When zone time is not used, set zone time to “0”.
18/ ALARM SETTING
Press “ALARM” button to show alarm time and the “ALARM” icon will appear. Press again to enable or disable
the alarm. Bell icon “ ” appears when alarm is enabled.
Hold “ALARM” to enter alarm time setting mode. Press “
▲
”or “
▼
” to enter the desired Hour/ Min values and
press “ALARM“ to confirm setting.
19/ SNOOZE & BACKLIGHT
When alarm is going off, press SNOOZE/ LIGHT to trigger snooze function and “Zz” icon will appear. To stop
alarm for one day, press “ALARM” key.
Once adapter is connected to the monitor, it will provide continuous backlight to the display
Press SNOOZE/LIGHT for an extended backlight if adapter is not connected.
20/ LOW BATTERY INDICATION
Low battery indication is available for the monitor itself and all of the remote sensors. Replace
the batteries and follow the setup procedure in this instruction manual.
Important:
Wind direction calibration is required for the anemometer during battery replacement
(Details refer “Calibrating the anemometer & installing batteries” section)
21/ BATTERY DISPOSAL & PRECAUTIONS ON THE USE OF BATTERIES
- Replace only with the same or equivalent type recommended by the manufacturer.
- Discard a used battery in nature or garbage pollutes and prevents the recovery of recyclable materials.
It is therefore important
to limit consumption of batteries
and follow these guidelines:
focus on alkaline batteries (that last longer than the saline batteries) and when possible, rechargeable
batteries
deposit batteries and accumulators in specific containers arranged among traders.
For example, metals will be valued and polluted the environment because they contain heavy metals hazardous
to health and the environment primarily (cadmium and nickel)
- The piles must installation by respecting the polarity indicated on the apparatus and the pile.
An incorrect positioning can is to damage the apparatus, is to cause escapes on the level of the pile, is to the
extreme to cause a fire or the explosion of the pile.
- To ensure proper operation, the batteries must be in good condition. In case of abnormality in the functioning of
the device, put fresh batteries
- Never attempt to recharge non-rechargeable batteries. They could run, warm up, causing a fire or explosion.
- Replace all batteries at the same time.
Содержание SM55PRO
Страница 12: ......
