Innowater SMC10, Руководство пользователя, Страница: 14 / 18

SMC 12
8.6 pH config
This menu is used with the pH Wireless option. See the
Wireless Pump manual for configure the function.
8.7 Factory configuration
This menu is used for factory settings and its parameters
must not be modified by the user.
9 Fault messages
This screen is displayed when the water does not contact the probe in the cell and the
control system stops the production. Firstly verify that there is water in the cell and that
its level reaches the top where the probe is located.
A low water level in the cell may be due to a dirty filter, obstructed skimmer basket,
obstructed pump basket or to a pump not powerful enough. As soon as the water level
is restored the fault disappears.
This screen appears when the salt concentration in the water is too low. At this stage it
would be best to take a water sample up to your local pool professional for testing and
then add the required amount to maintain a level between 3000 - 4000 ppm. As previ-
ously advised, wait until the additive is completely dissolved before running the chlorin-
ator. Then press any key to restart the chlorinator.
PLEASE NOTE: This screen can also be displayed if the water temperature is too low, if
there is a bad electrical connection between the control unit and the cell or if there is
calcium built up on the electrodes. If the water test shows your salt levels to be correct
please assess the cleanliness of your cell, the cell connection or it may be a fact of cold
water temperature only.
MAIN MENU
6 pH config
MAIN MENU
7 Factory conf.
LOW WATER
LEVEL IN CELL
SALT TOO
LOW