Innovative Technology NV9 Spectral, Быстрый старт

Страница: 10 / 27

NV9 Spectral Quick Start Guide
<< Back to Contents
Copyright © Innovative Technology Ltd 201 8
Doc:PA02093
Version: 1
Page 9 of 26
2.5.1 Configuration button functionality
2.5.1.1 Bezel flash counts
The NV9 Spectral Validator leaves the factory preset to at least one currency and
one interface so that it is ready for immediate installation. The dataset and interface
used are shown on the label fixed to the top of the validator head.
2.6 Fault codes
Number of LONG
flashes
Number of SHORT flashes
1 2 3 4 5
1 Note Path Open Note Path Jam Unit Not
Initialized Sensor
Covered
2 Cash Box
Removed Cash Box Jam
3 Firmware
Checksum Interface
Checksum EEPROM
Checksum Dataset
Checksum Note Float
Incompatible
4 PSU too Low PSU too High
Action Power status Function
Press and hold (more than 2 seconds)
until the bezel illuminates, then release Powered ON Sets validator
Press twice (within half a second) Powered ON Shows current interface
type (see flash count
table below)
Press and hold as validator is powered
up Powered OFF /
ON
Resets to factory
settings
Flash Count Interface
1
SSP
3
MDB
6
ccTalk
7
SIO
8
Parallel
Information
ccTalk and SSP are
currently implemented