Predator 2400
Owner’s Manual
OIPB-
IO-2003-P2400 GRINDER
7 |
P a g e 0 1 / 1 7 / 2 0 1 9
F.
EXCLUSIVE WARRANTY
Except as is expressly set out in this limited warranty: (i) Innovatech makes no promise
or warranty, expressed or implied, with respect to the equipment; (ii) Innovatech makes
no promise or warranty that the equipment is fit for any particular purpose; (iii)
Innovatech will have no obligation or liability to the purchaser or to any third party with
for any damage caused by the equipment or as a result or consequence of any claimed
defect in the equipment, any failure to warn or notify, or any claimed non-conformity to
the specifications; and (iv) Purchaser will have no other remedies in respect of such
defect, non-conformity, damage or condition except those set out in this limited
warranty.
SAFETY PRECAUTIONS
1.
Only persons who have received training are permitted to operate or repair the grinder.
2.
Use personal safety equipment such as steel toe shoes, safety glasses, and earplugs.
3.
Do not use grinder in area where there is a risk of explosion or fire.
4.
Do not start the machine with heads off the ground.
5.
Make sure the splashguard is on before stating machine.
6.
Before you start grinding, check the floor for bolts, large holes and uneven joints. Hitting
these things can damage machine, tools, and cause personal injury.
7.
Make sure all power supply is connected with the right voltage.
8.
Use only cold water in water tank. Do not use chemicals in water tank.
9.
When filling water tank, to avoid electrical hazards and injury, do not spill water onto the
machine motor and electrical box.
10.
Switch off the machine power before changing grinding tools.
11.
Disconnect power supply before working or repairing machine.
12.
Be very careful with rolling machine on any sloping floors or ramps. The machine can
roll very quickly. Two people may be needed to handle and control the machine.
13.
Use caution with removing the grinding tools after finished grinding. Tools can be very
hot. Use gloves to remove the plates.
14.
When grinding glues, epoxy paints, or coatings, leaving the machine down on floor
could cause the head to stick to the floor. Always tip back machine as soon as the head
comes to a complete stop.
15.
Always store machine in a dry place.
16.
Only use Innovatech recommended tooling.
17.
The operator must never leave the machine unattended during operation.
18.
When grinding dry, use a suitable vacuum to extract the dust.
19.
Innovatech is not responsible for any off gassing of hazardous gas that is generated by
grinding materials. It is the responsibility of the operator. Grinding floors containing
asbestos is especially dangerous and can cause health problems. Contact your state or
country for the proper way to handle it.
