3.3.2
Adding and Logging MTS channels
The Innovate Motorsports’ MTS (Modular Tuning System) allows you to
daisy chain multiple devices together via the serial IN and OUT connectors to
form one single synchronous log. MTS log chains can consist of a single unit
connected directly to a laptop (connect your
MTX-D
directly to a computer,)
two units, or multiple devices connected together, up to 32 channels. Below
is a MTS logging example using a PL-1 to record the information on a SD
memory log:
Innovate Motorsports’ MTS devices have two types of serial interface
connectors, the legacy 2.5mm stereo and the 4 pin Molex. The following
patch cables are available to interface your devices together:
4 Pin Molex to 4 Pin Molex - 4ft
p/n 3846
2.5mm to 2.5mm Stereo - 4ft
p/n 3760
2.5mm to 2.5mm Stereo - 6in
p/n 3789
4 Pin Molex to 2.5mm Stereo - 4ft
p/n 3812
To daisy chain MTS devices together
1. Power OFF all your MTS devices.
2. Start with the first product in the serial chain. Using the appropriate
mating cable, connect the OUT port from the first device and feed it
into the IN port of the second device.
(Note: If you have an LC-1,
there must be a terminator plug in the serial IN if it is the first device
in the serial chain.)
3. Continue connecting the OUT port of each device into the IN until
all your devices are connected together.
4. If a recording device is not connected to the serial chain, e.g. DL-
32, LM-2, the OUT port of the last device can be connected directly
to a computer to log with the LogWorks software
5. Once all the connections of the ports labeled IN and OUT are made
the MTS devices can be powered ON.
