Innohome Stove Guard SGK5010, Инструкция по установке и эксплуатации

Страница: 19 / 24

Checking the
sensitivity level
1. Remove the Sensor from the
installation plate. (The Sensor
gives 4 “beeps” ( ) and the
cooker is switched off.)
2. Press and hold the button
(approx. 10 sec.) until 2 “beeps”
( ) are heard.
3. An unadjusted Sensor’s sensi-
tivity setting is level 8, and when
checking the level, the Sensor
gives a set of “beeps” as follows:
8 - 8 - 5 - 8. If the sensitivity was
adjusted to level 4, the sensor
would give “beeps”: 4 - 4 - 5 - 4.
Reset the Heat Sensor
to factory settings
Remove the Sensor from the
installation plate. (The Sensor gives
4 “beeps” ( ) power is cut off
to the cooker).
1. Remove the battery lid.
2. Press the button once.
3. Return the battery lid. The Heat
Sensor shall make a "beep".
4. Press and hold the button until
the three "beeps" are heard.
Release.
If three "beeps" cannot be heard,
something went wrong. Repeat
from Step 1. Return the Heat Sensor
to its installation plate and press the
button once.
“BEEP” “BEEP” “BEEP”
1
2
3
4
Watch the film:
https://vimeo.com/321504101
Checking sensitivity
Watch the film:
https://vimeo.com/321504446
Factory settings
“BEEP” “BEEP”
19
Pairing devices
The units are already paired at the factory.
When replacing the Heat Sensor or the Control Unit,
the devices must be paired again.
Note!
The Heat Sensor must be
placed on the installation plate
during pairing.
1. Check that the cooker is
connected to the power
supply.
2. Press and hold the reset
button firmly for 20 seconds.
The Control Unit will emit
two sets of clicks and buzzes
(approximately after 5 and
20 seconds). Release the
reset button after the second
set of clicks and buzzes. The
Control Unit is now ready to
be paired.
3. Press and hold the NEW
Heat Sensor button until
it emits a “beep” ( ) and a
red LED flashes. The Control
Unit makes a buzzing sound
and the Heat Sensor emits a
“beep” ( ).
4. After 5 seconds, the Heat
Sensor gives an alarm (first
one "beep" and after a while
continuous beeping). The
Control Unit and the Heat
Sensor are now successfully
paired.
5. Reset the test alarm by press-
ing shortly the Heat Sensor
button. Check that the cooker
can be turned on. If the Heat
Sensor does not respond or if
the test alarm cannot be re-
set, see FAQ, page 22, points
5 and 6.
Reset
button