Notes
18
Notes
The product eBox touch must always be used
in conjunction with the eClick.
Electric vehicle charger characteristics according
to IEC 61851-1 Ed. 3:
1. The product must be connected to an AC
mains.
2. The product is connected permanently to
the mains.
3. The product is eClick-compatible.
It is available in the variants with a type-2
socket and with a type-2 plug with attached
cable.
4. The product is compatible with electric
vehicles charged with AC in mode 3.
5. The product can be installed and used in
protected indoor areas and unprotected
outdoor areas exposed to rain and direct
sunlight.
6. The product can be used in closed-off and
public areas.
7. The product can be installed on walls and in
compatible Pole products.
8. The product eBox touch in conjunction with
the eClick or coverage is rated electrical
protection class I.
The open eClick is rated electrical protection
class I.
Maintenance/repair
The eBox is a maintenance-free product.
It does not contain any reparable parts or
components. Do not carry out any repair work.
In case of a permanent error, replace the eBox.
Disposal
The eClick and the eBox are are electrical
devices. These must be disposed of accordingly
in compliance with EU Directive WEEE II, the
ElektroG of 20 October 2015 in Germany, or
the VREG, SR 814.620, of 14 January 1998 in
Switzerland.
Cleaning
The eBox may only be cleaned with water; the
use of lukewarm water is recommended.
Do not use any cleaning agents containing
solvents.
Disassembly
To disassemble the eBox, you first have to
disconnect the power supply. First unscrew the
two grub screws on the side and remove the
eBox from the eClick by pulling down the locking
bracket, removing the charging unit and, if
necessary, the Ethernet cables which connect
the eBox and the eClick.
Danger
The eClick must be disconnected
from the power supply before
disassembly.
Make sure that all components
are dry during disassembly.
