Important Safety Instructions
This section provides basic safety information for your Innoband 8012-G1 ADSL 2/2+
modem.
Prior to using your modem, carefully read and understand the safety instructions. These
instructions must be followed to reduce the risk of fire, electric shock, or personal injury.
o
Make sure that your modem is not exposed to direct sunlight or excessive heat radiation.
o
Keep your modem at a place where there is minimum risk of spilling any liquid.
0
o
The surrounding ambient temperature must not exceed 40 C (104
0
F).
o
Avoid humid conditions. Do not place the product near a water source or outlet such as a
bath tub, sink, wash bowl, laundry tub, swimming pool, rain, wet or humid wall, and so on.
o
Never clean your modem with a damp cloth or use any liquid cleaner.
o
Do not press, put any weight, or bend the power cord connected to a telephone
equipment.
o
To avoid risk of an electric shock during lightning, do not use any telephone equipment
that is connected to an electric socket.
o
In case of a gas leak, do not use any electric switch that is located in the vicinity of the
leak.
o
To report a gas leak, do not use any telephone equipment that is connected to an electric
power outlet in the vicinity of the leak.
o
Do not use any electric product, electric cord, or power socket that is even partially
damaged.
o
Do not expose yourself to dangerous voltages by opening the cover of your modem or
dismantling it.
o
You must not access the internal assembly or circuit board of your modem — none of its
parts are user replaceable.
o
Do not dispose off the batteries in fire — they may explode and cause injury. Besides, you
must follow the local codes for special disposal instructions.
o
If your modem needs any service or repairs, only qualified service personnel must handle it.
Model and Serial Numbers
Your Innoband 8012-G1 has model and serial numbers. You can find it on the bottom of your
modem. Note down the model and serial numbers for future reference.
Minimum System Requirements
For a proper operation of your Innoband 8012-G1 ADSL 2/2+ Modem, refer to the minimum
system requirements listed below:
1.For your computer connected to the Ethernet port
•Intel Pentium 350 MHz or equivalent processor
®
®
•Microsoft Windows 98 SE
®
•30 MB of free hard disk space
•64 MB of RAM
•Installed Network Interface Card with an RJ-45 port
Introduction 15
