Inno Essentials Silk'n REVIT PRESTIGE ND9002, Руководство пользователя

Страница: 27 / 173

26
EN
• Always unplug the device after charging has
been completed.
It takes about 3 hours to fully charge the device. When
the charging process is completed, the LCD display shows
the charging status as full.
Option 1 (via mains supply):
1. Place the device 1 onto the charging cradle 7 by fitting the
hole in its bottom to the pin of the charging cradle.
2. Connect the USB cable 13 to the charging cradle and connect
its USB connector to the USB adapter
12
.
3. Plug the USB adapter into a mains socket.
Option 2 (via USB port):
1. Connect the USB cable 13 to the charging cradle 7 with the
device properly installed.
2. Connect its USB connector to a compatible USB power source.
6. Operation
• Clean all parts of the device before first use as
described in the chapter “Cleaning and maintenance”.
• Make sure the filter, O-ring and the desired tip have
been installed properly before use.
• Before treating an area for the first time, perform a
skin sensitivity test on a spot. If you have no adverse
reaction, start your treatment.
• Always start on the lowest suction level and stroke no
more than 2 times over each area for your first treatment,
or until you have determined your ideal treatment setting.
• Do not use additional treatment products such as oils
or ointments.
• The device will switch itself off after 9 minutes of
continuous operation. It is recommended not to
perform a facial treatment for more than 4 minutes.
• When the power level is low, the device will alert with
2 beeps every 30 seconds and the battery symbol
on the LCD display will blink. Refer to the chapter
“Charging” to charge the device.