15
Integriti.
Integriti.
Integriti.
Integriti.
Integriti.
Colour Graphic Terminal User Manual.
Turning Area/s ON.
Logon to the Terminal as described earlier.
(PIN code + <OK>)
After the greeting (if enabled), the display will
show the Area Status etc. as before. The currently
selected Area is highlighted. Another Area can be
selected as described in “Turning Area/s OFF”.
If you are allowed to control more than one Area,
or the 24 Hour (Tamper) part of an Area, the
DISPLAY MODE can be changed as described in
“Turning Area/s OFF”.
After selecting an Area that is currently Off, turn
the displayed Area (or Area List) ON by pressing
the <ON> key.
After the <ON> key is pressed, this message is
displayed briefly while the system tests the state of
all the inputs allocated to the Area to ensure that
they are in the Sealed condition and the Area is
ready to be turned ON.
If all Zones programmed to be tested are Sealed,
the Area will turn ON.
Display briefly shows:
IMPORTANT NOTE: Some systems in high security applications may have the Pre-
Arm “Walk Test” feature enabled. In most systems this feature is not enabled and the
Area ON procedure will simply be performed as described below.
If Walk Testing is enabled on your system, the same procedure is followed except that
after the initial test to ensure that all Zones are Sealed, the system then enters Walk
Test mode.
Refer to “Area Walk Testing” in the Integriti LCD Terminal User Manual.
See “Quick Arm/Disarm” under “Turning Area/s OFF” for additional information.
-
,
Area Control
Admin
Sales Counter
Warehouse
Board Room
Training Room
Menu
OK=On
Area Lists
Turning Admin On
or
Area On/Off
