22
How to Stabilize the Dynamic Desk
After placing the unit where it will be used, check its stability. Thread all four levelers in completely. Level the unit using
the two rear levelers. Bring the remaining two levelers down to contact the fl oor.
If there is even a slight rocking motion or the unit is not stable, determine which stabilizing leg is not resting on the
fl oor. To adjust, loosen the JAM NUT (A) and turn the STABILIZING LEG (B) until the rocking motion ceases and both
stabilizing legs rest fi rmly on the fl oor. Retighten the JAM NUT.
Note:
It is extremely important that the stabilizing leg be correctly adjusted for proper operation.
Checking the Belt
After the Dynamic Desk has been installed and stabilized, the belt must be checked to confi rm proper tracking. First,
ensure the power cord is plugged into a suitable outlet, as
described in the above Electrical Requirements section.
Then turn the Dynamic Desk on. Stand on the side rails of
the Dynamic Desk and straddle the belt. To start the belt,
press the GO key, then press the SPEED UP arrow key until
the Dynamic Desk reaches 2.0 mph/ 3.2 kph. If the walking
belt appears off-center, see the instructions in
Tracking (Cen-
tering) An Existing Or New Walking Belt (Section 9.4).
Note:
Normal belt operating position is for the belt to be
located within the belt travel position indicators on the motor
cover (see illustration to the right). If the belt is not in this
position, see
Section 9.4.
Moving the Dynamic Desk
Turn the Dynamic Desk off and disconnect its power cord,
then raise its deck.
Note:
If adjustments were made to the levelers during setup, make sure to tighten the levelers snug against the base
frame before moving.
The Dynamic Desk may now be moved on its front platform wheels by raising the back of the product and pushing /
pulling. Do not attempt to move the Dynamic Desk by pushing or pulling on the deck, uprights, or desktop.
Immobilizing the Dynamic Desk
When it is necessary to immobilize the Dynamic Desk, press and hold both the SPEED DOWN ARROW and the PAUSE
keys on the integrated user controls. Use the same key sequence to mobilize the Dynamic Desk.
9 mm
18 mm
A
B
Содержание DYNAMIC DESK
