InMotion inDVRL408RTN, Руководство пользователя

Страница: 48 / 104

47
I/O ALARM : Each channel corresponds to an I/O status (see the following status explanations),
which means that when an alarm is triggered, it will activate the corresponding channel to start
alarm recording.
I/O status types:
N.O.: “Normally open”: It means that in its normal state, the sensor is kept under constant low
voltage. If the sensor voltage changes from low to high, then the alarm will be triggered.
N.C.: “Normally closed” (also referred to as “normally connected”): The normal state of the
sensor is under constant high voltage. If the sensor voltage changes from high to low, then the
alarm will be triggered.
OFF: Set the I/O to “Off” if external sensor alarms are not in use.
OUTPUT :
³¥
” indicates that an alarm will sound if it had been triggered by sensor.
RECORD :
³¥
” indicates that the relevant channel will record if it has been triggered by
activity detected by the sensor.
BUZZER :
³¥
” indicates that the buzzer will sound if it has been triggered by activity detected
by the sensor.
Prerecord :
³¥
” indicates that the relevant channel will prerecord for 5 seconds if it has been
triggered by activity detected by the sensor.
Email/FTP :
³¥
” indicates that the picture of relevant channel will be sent to the pre-registered
email address and FTP if it has been triggered by activity detected by the sensor.
0RELOH$ODUP³¥
”indicates that an SMS will be sent to the pre-registered phone number when
an I/O alarm has been triggered.
Note : If the “OFF” setting is selected for any of the preceding options, the relevant alarms and
notifications will not take place, regardless of activity near the sensor.
5.6.7 Motion Detection
To access the “Motion Detection” menu,
in
the toolbar, first click “System
Settings,” then click Alarm.” Next, select
“Motion” and click “>>,” and the dialog
window where Sensitivity, MD Detection,
Output, Record, Buzzer, Prerecord, and
email settings can be set will appear.
CHANNEL : In this field, select the channel
to be configured.
SWITCH : Each channel has a corresponding channel switch; press “Enter” to turn the motion
detection for each channel on or off.