INMES Industrial Ltda – IM-30 MM
16
10 –
TROUBLESHOOTING
Problem
Probable cause
Suggested Solution
Motor does not work
Main feed cable not connected
Connect the main feed cable
Circuit breaker off
Have circuit breaker checked
ON/OFF switch button damaged
Get authorized service
Defective contactor (three phase)
Get authorized service
Motor burned
Get authorized service
Motor rotate to the
wrong side
Electric installation
Invert the direction of the motor rotation
Motor does not
work fine during
cutting
Saw blade not sharpen
Have it sharpen
Excessive cutting speed
Lower cutting speed
Model of the saw blade
Use blades with less teeth
Use anti-kickback blade
Frequent
disconnection of the
circuit breaker
Motor over-loaded
Descent the blade slowly
Have the motor bearing checked
Undersized circuit breaker
Install a circuit breaker with proper amp.
High level of noise
Motor bearing damage
Get authorized service
Motor problem
Get authorized service
Rough cuts
Saw blade not sharpen
Have it sharpen
Awkward blade
Replace the blade
Blade incorrectly mounted
Mount the blade correctly
Blade missing teeth
Replace the blade
Motor bearing damage
Get authorized service
Excessive cutting speed
Lower cutting speed
Angle of cut not
accurate
Moulding fence misalignment
Get authorized service
Saw blade misalignment
Make the alignment
Awkward profile
Try another cut with a straight profile
Profile moves during cutting
Secure the profile in place before cutting
Saw blade not sharpen
Have it sharpen
Debris between the profile and moulding fence
Clean it up
Hard to pull
Back
Mains spring is broken
Replace the spring
Hex nut from pivot shaft is too tight Release
the nut slowly
WARNING
!
For your own protection, always switch “Off” and remove plug from power source outlet before
troubleshooting.
