Inline IN2118, Руководство по эксплуатации

Страница: 8 / 27

6
IN2118 Operation Manual - Preliminary 01/31/01 ©2001 - Inline, Inc.
5. Most installations will require fabrication of a new cover surface (lid). Using the IN9185
template, make another outline on a matching piece of material. Cut out the new lid
using a power / saber saw.
Note: Bear in main that the new surface must accommodate a 1/32” gap on all four sides
between the lid and the table opening.
6. Finish the top and sides of the lid, and the sides of the opening in the table. Again, there
should be a 1/32” seam around all four edges of the lid when it sits flush with the table
surface.
Note: If matching lamina is unavailable, installers may have to completely resurface the
table / presentation furniture, or consider other installation options.
Installers may wish to use 1/32” feeler gauges to achieve precise
equidistant spacing on all four sides of the lid. Hint: A standard size
paper clip (one and one quarter inches long) is almost 1/32” in diameter.
7. The
IN2118 is secured to a plate base to prevent damage during shipment. Disconnect
the four screws and remove the plate.
Note: The IN2118 is delivered with the top plate in the lowered position. Do not raise the
plate until the installation is complete.
8. Loosen the four (4) upper wing nuts and disconnect the mounting flange from the main
housing (see the Adjustments Diagram on page 8).
9. Working from the underside of the table, position the mounting flange so that the gap
between the inside edges of the flange and the table’s opening are roughly equidistant (a
precise adjustment will be done later). The flange contains eight (8) mounting holes: four
oversized primary holes on the corners and four smaller secondary holes on the sides.
The primary holes are used to position the unit, while the secondary holes are used to
permanently attach the IN2118 to the table / installation furniture. Mark the four (4)
primary holes only.
Note: Do not drill the secondary holes or permanently attach the flange until the unit has
been positioned properly!
10. Set the flange aside and carefully drill the primary holes. Care must be taken not to
penetrate the surface of the table. Drill the holes in the center of the oversized openings
to provide maximum centering flexibility.
11. Attach the flange to the underside of the table. Do not fully tighten the screws.
12. Attach the main housing to the mounting flange by securing the four (4) upper wing nuts.
Make sure that the top of the housing sits flush with all four sides of the flange before
tightening the nuts.
For applications in which a new table / presentation furniture will be fabri-
cated and / or the IN2118 will be installed at a remote location, the main
housing should not be attached to the mounting flange during shipment.