11
©1995 - INLINE, INC.
IN2013 OPERATION MANUAL - REV 1.1 12/11/99
INTERNAL DIP SWITCHES
In order to simplify operation, the IN2013 was designed so that dip switches needed by most
users are exposed through windows in the case metal while reserved switches and other dip
switches for highly specialized functions are covered. This helps prevent operational problems
which might occur if the dip switches were set to unusual settings but also provides the
flexibility so that advanced technicians may fully customize the interface settings if necessary.
The IN2013 will function properly for the vast majority of installations using the factory default
dip switch settings for all hidden dip switches.
Hidden dip switches must only be adjusted by qualified technicians as this requires the
interface to be opened and disassembled, raising the possibility of physical damage or static
discharge damage to sensitive internal components (not covered under warranty).
The IN2013 has three banks of dip switches as described below and shown in Diagram 3 on the
preceding page. Dip switches are made of thin, soft plastic and should be gently adjusted using
the Inline alignment tool provided or using another small tool.
SW1 - Output Sync / Horizontal Position Control Factory Default Settings:
0100001010
These dip switches are normally all covered except for #6.
Switch Number
Function When Set to ON (1)
1
N/C
2
Green Out (set opposite of Switch #3)
3
Monochrome Out (set opposite of Switch #2)
4
Manual Output Sync - RGBS (only works when #7 is set to OFF)
5
Manual Output Sync - RGsB (only works when #7 is set to OFF)
6
Horizontal Position Control Disable
7
Automatic Output Sync (Set to OFF for Manual Output Sync Select)
8
N/C
9
Reserved
10
N/C
Select RGB Output or Composite Monochrome Output
RGB Output (factory default)
#2 ON, #3 OFF
Composite Monochrome Outputon the Green Connector
#2 OFF, #3 ON
(RGB summed together along with Sync)
Setting Output Sync Format
The IN2013 with factory default settings automatically sets the output sync according to the
number of cables connected to the output BNCs. A green LED located next to three of the
output BNCs indicates that sync is present and also indicates the current sync format. If desired,
you may manually force the interface into a specific output mode. Please note that all 3 output
LED indicators turn on when the interface is set to manual output sync mode.
Automatic Output Sync Selection (factory default)
#7 ON
Manual Output Sync Selection
#7 OFF
Select RGBHV Output Sync
#4 OFF, #5 OFF
Select RGBS Output Sync
#4 ON, #5 OFF
Select RGsB Output Sync
#4 OFF, #5 ON