8
IN1401 Operation Manual - v1.5 7/12/02 11:18 AM
© 2002 - INLINE, Inc.
OUTPUT MENU
RESOLUTION - Because the IN1401 only scales up, users must choose an output resolution
that is greater than or equal to the input active area, as well as one that is compatible with
their monitor. The available resolution rates are listed on page 13.
REFRESH RATE - Allows users to choose the refresh rate that’s compatible with their display
device.
Note: Not all resolution and refresh rate combinations are available. Refer to the chart
on page 13 for a complete listing.
POSITION - Positions the output image on the monitor. Unlike input blanking it does not crop
the image or add blank borders.
BLUE SCREEN - Adjusts the output image on the monitor. Available anytime (even when the
input settings are incorrectly adjusted or the input signal is missed entirely), the blue
screen is used to adjust the outer settings (resolution, refresh rate and position) and verify
the image on the monitor. The video and input settings have no effect on the blue screen.
Once the output settings have been properly adjusted and verified on the monitor, the
blue screen may be turned off to adjust the video and input settings.
OPTIONS MENU
FACTORY RESET - Returns all video, input and output settings to factory default (except the
resolution and refresh rate).
AUTO DETECT - Four options are available:
•
Auto Detect On - The default mode at power up that allows the IN1401 to
automatically detect new input modes and adjust accordingly.
•
Auto Detect Off - Prevents the IN1401 from switching back and forth between
input modes, or flickering when small input changes occur (such as from a VCR in
fast forward or reverse).
•
User Defined - All input modes have the same user definable settings, however,
they are restricted to values close to the input mode detected. If a full range of values
is necessary, the user-defined mode may be manually selected.
Note: If auto detect cannot determine the input mode, the user defined mode is
selected automatically.
•
Redetected Now - The IN1401 automatically reconfigures when each new input
mode is detected and each new output mode is selected. In the event that the scaler
does not detect a change in the input mode, or should the input / output settings
become invalid, the Redetect Now option allows users to initiate a new detection
sequence and reload the input / output settings.
BAUD RATE - Allows RS-232 remote users to select the baud rate that matches their remote
control device system.
DELIMITERS - Use the on screen menu to select the desired command code delimiters.
INLINE scalers can be set to recognize six sets of leading and end codes when using an
RS-232 remote: parentheses ( ), brackets [ ], braces{ }, slashes \ /, less and greater than <
>, and signs !#. If desired, several INLINE products may be connected together on the
