Inkonova tilt, Инструкция по эксплуатации

Страница: 14 / 26

TILT Assembly Manual
Code No.: MD03001-00-1107
14
Step 13
Install the polymer
bearing in the IGUS
bearing housing. Then,
screw the servo bearing
housing into the servo
base with the M3x6
screws (keep the
middle bore empty).
Install the servo pulley
in the servo with the set
screws and then, the
servo in the base with
the M2 hardware.
Ensure the servo
pulley is aligned with
the polymer bearing.
Add the nylon cylinder
through the bearing and
screw the M3x20
screws to the pulley
through the Nylon
cylinder (use thread
lock here and do not
tighten excessively).
PARTS
 Servo base
 IGUS housing
 Servo

1x polymer bearings (small)

1x Nylon cylinder 15 mm
HARDWARE
 2x screw M3x6
 1x screw M3x20
 2x screw M2x12

2x washer M2

2x lock nut M2

2x set screw M3 (short)