TILT Assembly Manual
Code No.: MD03001-00-1107
13
Step 12
Mount the flight controller with the
M3x6 on the base plate (the picture here
is just orientative) and the PDB or PDB
substitution with the Nylon nuts on the
already installed Nylon screws (for the
PDB substitution you do not need the
nylon nuts as separators as there is no
shortcircuit risk).
We recommend insulating the bottom
side of the PDB with electrical insulation
tape. It is not mandatory as the PDB and
solderings should not touch the frame
(
CHECK!
). We used Kapton (Polyimide)
tape to insulate the PDB from the carbon
fibre chassis.
NOTE:
use tape with “low noise” glue
when possible. Some insulation tapes can
cause an increase in the noise in the
system. Using good quality tape with
suitable glue properties is good practice.
PARTS
Same as steps 9,
10 and 11
HARDWARE
4x screw M3x6
3x Nylon nuts
PDB substitution
(comes with all
frames)
