Position on turbo and tighten using 8mm nut driver. May need to be loosened
and
Install the intake tube and position to the turbo and step hose.
Tighten the clamps on the step hose using 8mm nut driver.
Postion for the best possible fit and tighten the clamp on the intake tube.
Install the temperature sensor into the intake tube using provided M4 screws and
secure. Connect Temperature sensor harness.
Install thefactory grommet into the pre-drilled 3/4” hole on the plenum.
Install the air filter gauge into the grommet and secure.
Check the entire system for the best possible fit. Once you have checked the
entire system for leaks, rubbing or rattling, continue to tighten all nuts, bolts and
clamps. Reconnect the negative battery terminal prior to starting the engine.
Page 5 of part# PF8075
Figure 32
Figure 31
Figure 30
Figure 29
Figure 28
Figure 27
Figure 34
Figure 33
