Flex5/R | © 2021 Inim Electronics S.r.l.
13
2.4 Flex5/R project
2.4.3 Enrolling of Flex5/R
Inim Electronics control panels allow the enrolling of peripherals in different ways, with a choice between
automatic or manual procedures, depending on installer access to the system.
Automatic, from control panel in ‘service’ mode
Placing the control panel in ‘maintenance’ mode activates automatic enrolling of peripherals on the BUS at
intervals of 10 seconds.
If the installer assigns addresses to peripherals connected to the BUS, at 10 second intervals, the control
panel will enroll in the configuration the peripherals it finds.
Automatic, from keypad
Alternatively, it is also possible to start an automatic enrolling process by means of the following installer
menu options:
Type in Code
(Installer)
, PROGRAMMING Default settings, Auto enrolPeriph
Manual, via Prime/STUDIO software application
Once the solution for the system to be designed has been opened, click on the
System Layout
button on the menu on the left. Then in the section on the right click
on the
Add device on BUS
button.
A window opens where you can select the devices to be configured and add them to the configuration.
In the section on the left you can increase the number using the button corresponding
to the selected device type.
To remove a device from the structure, work through the Add device procedure, but
instead deselect the device you want to remove
Alternatively, you can access the programming section by clicking on the relevant button on the menu on the
left, and from the list that appears click on the
Delete
button that corresponds to the line of the device to be
removed.
Manual, via SmartLeague software application
Once the solution of the system to be designed
[A]
has been opened, in the right ‘Design’ tab
[B]
, it is pos-
sible to select an icon of the type of peripheral to be configured and drag it to the relevant part of the tree
structure on the left
[C]
.
Alternatively, you can double-click on the device icon to add it to the configuration.
In the tree structure on the left, the number corresponding to the selected device type increases.
To remove a component from the tree structure, select it and press
CANC
on the computer keyboard.
