Configuration
7
Installation and programming manual
•
the “
Command addresses
section allows you to configure the KNX
devices which will activate actions on the SmartLiving control panel
(arm partitions, activate outputs, etc.). The address of the KNX
device that activates the signal/command to the SmartLiving control
panel must be indicated in the edit field of the corresponding signal.
•
The “
Status addresses
” sections allow you to configure the KNX
devices that will be activated by any changes in the status of the
SmartLiving control panel. The address of the KNX device that will
receive the signal from the SmartLiving control panel must be
indicated in the edit field of the corresponding signal.
To assign an address, press the “
” button (present in each edit
field) to open a window which will allow you to select the KNX device
from the imported tree structure.
CONTROL PANEL
“
Status addresses
” section:
This section allows you to assign the control panel event signals (1 bit,
ON or OFF) to the various group addresses. The group address entered
in the edit field corresponds to the KNX BUS device that will receive the
status change signal.
PARTITION
“
Command addresses
” section:
This section allows you to specify up to 5 devices on KNX BUS device
that will arm/disarm the partition. This operation can be done for each
partition and each partition arm/disarm mode.
“
Status addresses
” section:
for each partition and each partition arm/disarm mode, you can specify
a device on the KNX BUS device that the partition status message will
be sent to.