INIM Electronics Air2-OTT100W, Инструкция по установке и программированию

Страница: 9 / 12

Maintenance and periodic checks 9
Installation and programming manual
I
5
MAINTENANCE AND
PERIODIC CHECKS
Keep the lens clean to guarantee proper operation of the detector.
A lens which is not perfectly clean may cause detection problem.
The cleaning must be done when necessary or when clearly dirty.
CLEANING
PROCEDURE
Clean the lid and the lens with a cloth dampened with water.
Wipe with a dry cloth.
ATTENTION!
Do not use chlorine-based or abrasive products or alcohol to remove particularly
noticeable dirt.
6
DISPOSAL AND
SCRAPPING
DISMANTLING
1. Unscrew the screws that fasten the front lid and remove it.
2. Disconnect the detector; disconnect all the terminals on the terminal block.
3. Divide the parts by type and dispose of them in accordance with applicable
laws.
ATTENTION!
Do not dispose of the components or any other product material in the
environment.
Seek the assistance of companies authorised to dispose of and recycle waste
materials.
Table 9: Sensor programming
DIP 3
OFF ON
DIP 4
OFF
Triple AND:
MW + PIR 1 + PIR 2
Double AND:
MW + PIR 2
Each techmology must
detect a motion to activate
the alarm
The detection of the MW
and the detection of the PIR
2 activate the alarm (PIR1
disabled)
ON
Double AND:
MW + PIR 1
AND of:
MW + (PIR1 OR PIR2)
The detection of the MW
and the detection of the PIR
1 activate the alarm (PIR2
disabled)
The detection of the MW
and the detection of one of
the PIRs activate the alarm