![InHand InGateway502 Скачать руководство пользователя страница 100](http://html1.mh-extra.com/html/inhand/ingateway502/ingateway502_user-manual_2061305100.webp)
96
subnet mask of the virtual NIC is used as the peer IP
address.
o
Cipher: specifies the protocol used to encrypt the data transmitted
over the OpenVPN tunnel. The setting must be the same on the
client and server.
o
HMAC: specifies the authentication method used for data
transmitted over the OpenVPN tunnel. Data cannot be transmitted if
the authentication fails. The setting must be the same on the client
and server.
o
Compression LZO: specifies the compression format of data
transmitted over the OpenVPN tunnel.
o
Redirect-Gateway: enables the OpenVPN interface to act as the
default gateway for the client, so that all traffic of the client is
forwarded through the OpenVPN interface.
o
Remote Float: allows the remote device to change its IP address or
port.
o
Link Detection Interval: specifies the interval for sending link
detection packets after an OpenVPN tunnel is established. The valid
value range is 10-1800, and the unit is second.
Содержание InGateway502
